The unit was full of water and would not respond when I set it in the spin drain cycle. It would not energize the pump and would finally lock the door after about 2 minutes.
The unit would not do anything even in the service tests. I disconnected the water sensor pressure tube and could get it to fill. I could not get the service mode door lock test or drain pump test to work. I hooked up my meter to CN5 1 WHITE WIRE and CN10 6 black wire and set the service test mode Board Output Test for drain pump and the pump came on and drained . When i disconnected the meter it would not drain. When I reconnected the meter it would start again. I checked for failure codes and got the 22 door switch failure. Is it the main board or the door switch? How else can I test it?
- Guest asked 8 years ago
I have attached a tech. sheet for this model. All testing procedures and results will be outlined in this tech. sheet. Good luck
- Sam, Ace Appliance answered 8 years ago
- You must login to reply
Please login first to submit.