When I set the selector know on normal or anthing but Delicate or Rinse None of the LEDs for the water temperature selections or the spin speed will come on. ONlY a beep is heard. When I press start the washer comes on, will rotate to sense the clothes but then the sensing light goes out and it doesn’t fill. Why would it do this and will fill and let me select on delicate or rinse?
I need a tech sheet and any video what might help
- Guest asked 6 years ago
Hello
See the technician service manual link below. Start by diagnostic mode and see if you have any stored error codes.
READING ERROR CODES:
1. Wake the washer by pressing any button.
2. Wait 5 seconds.
3. Press and HOLD the Start/Pause and Cancel buttons simultaneously. As long as the buttons are held, the
failure code will appear in the display as an E followed by two numbers, a number and a letter or two letters.
The control will beep.
Troubleshoot the problem by using charts on the pages 3-5.
NOTE: During normal operation, the display may show:
“cd” – cool down (Sanitary cycle)
“do” or “dr” – door problem.
“Err” – an error has been detected.
“LOC” – control lock is activated.
“PAU” – cycle has been interrup
- AV Repair Help answered 6 years ago
- You must login to reply
Please login first to submit.
