the board lights up
i can select the option i want and when i press start nothing happens i see it trying to move to the cycle but nothing happens.
i did check the door switch and thermal fuse and all is good.
can it be the board?
- Guest asked 9 years ago
Hello. I have attached the tech sheet for you. Take a look at page 3 at the trouble shooting guide. Second symptom down it says “WON’T START CYCLE START BUTTON IS PRESSED”. Follow the steps, which has you do test 2 on page 5 and test 6 on page 10. What are connections p3 and p4? I show those as the user interface connectors. You should have the connector and then the pin numbers. For example p1-3 and p1-4. P1 is the connector and 3 and 4 are the pins on the connector. The board could be faulty. Most of the time you will have a burnt spot on the back of the board. I have seen many of theses boards fail for this same symptom. Your motor could be faulty as well. The tech sheet also shows how to test the motor.
- Brian, Ace Appliance answered 9 years ago
- You must login to reply
Thanks for your question.I attached a link to a similar issue (however video is of an electric dryer)with diagnostic procedure for your no start issue.
- Sam, Ace Appliance answered 9 years ago
-
I checked its not the belt switch Also I’m getting OL on P3 and P4
- You must login to reply
Please login first to submit.
