it dose drain and spin but when it fills with water it leaks out from the bottom of the front door
- Guest asked 8 years ago
Did you change the door boot ? If not change it. I would then go to section 3-1 through 3-13 on troubleshooting and diagnostics for the timer and start button. This diagnostic manual walks you through every step.
- AV Repair Help answered 8 years ago
-
I did change the door boot and I have the same issue.. the washer fills with water and the door lock goes off. I believe there may be too much water in the tub. can that be?
- You must login to reply
The first thing to check would be a full visual inspection of the rubber boot that goes around the inside of the door. Make sure that the lip that seals it to the door does not have and rips or tears in it. Also pull the seal back and inspect the inner portion of the seal for any small rips or tears. If there are are any holes this will cause water to leak out the front. Also make sure the door glass is completely clean. If it gets layered with hair or any debris the door will not make a good seal and can cause a path for the water to travel and leak out the front as well. The door boot part# for this model is 12002533. Hope this helps.
- AV Repair Help answered 8 years ago
-
How to change the door boot and I still get leaking . I’ve also noticed a timer does not work properly when I push the start button and will not start I would have to adjust the timer little bit at a time for the start button to click on .
-
any update on what the issue can be?
-
??? can it have to do with the timer?
-
so I changed the door boot and the timer I cleaned out the pump. and it still leaks when it’s mid cycle. I also noticed that the temp was set to cold and the load was very very hot. please advise
- You must login to reply
Please login first to submit.