When I push the power button select cycle push start normally the you will hear the door latch lock and the sensing light will light then the washer will go thru its regular routine of going thru the wash cycle. Now when I push the power button, select the cycle, push the start button NOTHING WILL HAPPEN, NO ERROR CODES!
I ohmed the door latch, the signal contact closed also I think it is a 120 volt contact that also closes. I used the tech sheet to check the main PCB and the green light flashed for a few seconds then it stays lit. (tech sheet good PCB) Could it be the interface? Any help would be helpful. Thanks Ricky
- Apache Warrior asked 8 years ago
Hi. The model number you gave me is for a front load washer. It seems to me that you are describing a top load washer. In the diagnostics of this front load you can select the second button to run a test cycle. It is strange that the green LED blinked. I believe it should stay solid green all the time. This, along with no error codes makes me think you have a loose connection somewhere. Most common would be at your outlet. Will the unit light up for you?
- Brian, Ace Appliance answered 8 years ago
-
First of all Thank you! Second is the washer will not go into diagnostic mode. hopefully this will help. Thanks Ricky
- You must login to reply
Please login first to submit.
