This is the same question that I asked yesterday but I gave you the wrong model and serial numbers.
The washer fills, agitates, empties then stops. Board flashing ON, SPIN, LIdLOCK. Shuts down.
I checked the lid lock to see if it was in good condition- yes. I ran it through 2 different cycles and it does the same thing.
It’s a GE and not a manual timer.
- Guest asked 6 years ago
Hello
See manual link below. Go to page #4 . This will walk you step by step through the flashing board lights. That is an error code that you will see on page #4. Matt Ace technician
VERIFY IF WASHER IS IN CRITICAL ERROR (SEE CRITICAL FAIL MODE TABLE).
TO ENTER TO SERVICE MODE, ROTATE CYCLE SELECTOR TO ANY POSITION EXCEPT POSITION 6.
PRESS START BUTTON AND FS BUTTON AT SAME TIME, WAIT 3 SECONDS, THEN ROTATE CYCLE SELECTOR TO POSITION 6, WAIT 3 SECONDS
AND RELEASE BOTH BUTTONS AND ALL LEDS WILL BLINK.
ROTATE KNOB CLOCKWISE TO VARIOUS POSITIONS PER SERVICE FUNCTION TABLE TO PERFORM FUNTIONAL CHECKS.
FOR TESTS MARKED WITH IN SERVICE FUNCTION TABLE IT IS NECESSARY TO PRESS START BUTTON.
WHEN A LOAD IS TESTED, IS NECESARRY TURN THE PROGRAM KNOB TO OTHER POSITION TO TURN OFF THE LOAD.
TERMINATION OF SERVICE MODE CAN BE ACCOMPLISHED BY REMOVING POWER TO THE WASHER, OR REPEATING
THE SAME PROCEDURE TO ENTER TO SERVICE MODE, OR WAITING 15 MINUTES.
* FLASHING
1 LED ON
0 LED OFF
A LED ON IF THE SHIFTER IS IN AGITATE POSITION
LED OFF IF THE SHIFTER IS IN SPIN POSITION
B LEDS WILL BLINK AFTER START BUTTON IS PRESSED INDICATING
ERRORS ARE CLEARING. AFTER ERRORS HAVE CLEARED, MOVE THE
CYCLE SELECTOR TO POSITION 3 TO VERIFY THAT NO ERRORS EXIST
- AV Repair Help answered 6 years ago
- last edited 6 years ago
- You must login to reply
Please login first to submit.
