Washer isn’t going into spin cycle?
I’m not sure, maybe the diverted valve isn’t switching to drain all the water. Some water is in the tub. It’s not alot but won’t go into spin. Can the motor be bad.
- Guest asked 9 years ago
The diverter valve should get 120 volts to it. I had one recently that was not getting the proper power. Found this out after I already had put a new one on. It ended up being the control board not sending correct voltage. New board fixed it. Check to see if it drains any water out. See if when it is suppose to be draining if you are getting water recirculated back into the tub. This would be a sign of a faulty diverter. You could have a faulty drain pump or something clogging it.
- Brian, Ace Appliance answered 9 years ago
- You must login to reply
hello, if the washer is not draining it will not go into spin cycle. The diverter valve is a common issue for these washers, i could not find a real good video on this valve. it is located on the bottom of the washer, just tip it back and you will see it. I provided a link for the part.
- Guest answered 9 years ago
- You must login to reply
Please login first to submit.
