I put new belts on my washer. it was tilted back so when i turned it on it went to wobbling and then cut off. since then i put it back down on the floor to let the water level out and it will not start.
- Fred Abernethy asked 6 years ago
It sounds like your out of balance switch was just triggered because the tub went back and hit the out of balance switch lever hanging from the top panel of the washer behind the tub. You’ll need to open the lid, straighten the tub, then open and close the lid fully once or twice and that should reset the switch. If that doesn’t work, then you may have to unscrew the bottom of the front panel, remove the front panel, then unscrew the bolts going into the upper front right and left corners holding the top panel down. The top panel will then hinge up and backwards. You can then look at the lever system below the top panel to try to reset it and if it’s already reset but won’t work, the switch assembly inside the control panel above the outer of balance lever needs to be replaced.
- AV Repair Help answered 6 years ago
- You must login to reply
Please login first to submit.
