Electrolux. No matter what setting it’s set to the washer always uses scorching hot water. Coworker replaced valves and main board still only using hot water though. I have a kenmore today with the same issue and just wanted to know what it could be causing it? Hoses installed correctly, settings are properly set..
- Guest asked 7 years ago
Other than the information provided, the only other possibility may be a failed “flood safe ” type of supply hose. I have seen this multiple times, so you may want to be sure to eliminate that as a possibility as well.
- Sam, Ace Appliance answered 7 years ago
- You must login to reply
Hello
Have you run the unit throgh diagnostics ? If not see manaul below . There are only two other possibilities.
1) Make sure the inlet hoses are not reversed .
2) Your wiring diagram shows a (NTC) thermistor. They are resistors with a negative temperature coefficient, which means that the resistance decreases with increasing temperature. I am not sure if your NTC is built into your board or if it is a separate external part near the main control board. Call your parts distributor to see if you can get the NTC separately. This will definately cause your issue if its not part of the board. Matt Ace technician
- AV Repair Help answered 7 years ago
- last edited 7 years ago
-
This other kenmore doesn’t seem to have a temperature thermistor. 41741122310 Should I jut assume it’s the board?
- You must login to reply
Please login first to submit.
