It a 2010 unit and customers states that it will start, go thru the sensing cycle and then not advance anymore. Tub sometimes may be slowly turning. Lid lock light will be blinking. Sometimes she is able to unplug washer and restart, then it will work. If she is able to get it started, at the end it has not spun out. Water will be drained. Thinking lid lock issue here.
Checked fault codes – none. Ran it thru automatic test cycle. Everything worked. Tub turns freely and moves freely. Lifts freely. With nothing to lose, decided to run calibration cycle. After 10 minutes, it still had not finished and the lid lock light was blinking. Beginning to think it’s a control board issue now.
I don’t see this machine too much to become an expert on it. Seems when I do, it’s always something new.
Thanks.
- Gary Williams asked 9 years ago
Likely the washer is not “sensing” the motor movement. More likely to be a bad shift actuator, which also has the rpm sensor built into it. Have not had a bad board on one of these yet or lid lock unless someone forced the lid open. “Flashing lid” usually means there is an error sensed.
- AV Repair Help answered 9 years ago
- You must login to reply
Please login first to submit.
