I did an error code diagnostic and it showed to be the shifter,i replaced the shifter, and then the lid lock lite come on blinking, then i did an error code diagnostic and it showed that the lid was bad, i replaced it and now when i try to go into manual mode it will not lock the lid and will not do nothing , all lites are on
Tried the lid lock replacement the shifter replacement i am thinking its the board. On one of your videos Jimmy states that the reference service pinter indicated to be the board. What is this Reference Service Pointer?
- Guest asked 9 years ago
I do not see a service pointer on your exact model for this issue. After you install an actuator you need to run a calibration cycle. To do this go into the diagnostic mode just like you do for the error codes. When all the lights are blinking turn the knob until just the rinse light is lit up. Press start and the unit will run a diagnostic cycle. This take about 4 mins. I do not think this is causing your issue but it needs to be done to avoid other issues. Also, lets clear the error codes from the system. To do this enter the diagnostic mode again and with just the done light lit up press start to go into the error code section. All the lights will be blinking. Do not turn the knob. With all the lights blinking press and hold the start button until the lights go off. This clears the error codes and exits from the diagnostic mode. Reset the unit by unplugging it for 5 mins. During this time press and hold the start button for 10 seconds. Try running a cycle. If you still get a lid lock error code and you installed the lid lock correctly, you will need to replace the control.
- Brian, Ace Appliance answered 9 years ago
-
I have done all these I think contro board thanks briian
-
Sounds like it will be that board. Good luck. Your welcome.
- You must login to reply
Please login first to submit.
