If the sensor was encased in ice, you need to replace it as it is probably damaged or may be defective anyway. Re-locate the sensor to the outlet side of the evaporator just before the cap tube if it is not already located there. There is also some fairly common issues with the evaporator fan becoming intermittent or the plug to the evaporator fan coming off the unit due to the ice build up. We have even had to cut the harness and hard wire it to the fan in some cases.

This service data sheet is
intended for use by persons having electrical, electronic, and mechanical experience
and knowledge at a level generally considered acceptable in the appliance repair trade.
Any attempt to repair a major appliance may result in personal injury and property
damage. The manufacturer or seller cannot be responsible, nor assume any liability for
injury or damage of any kind arising from the use of this data sheet.
Models Covered:
RS267TDBP/XAA
RS267TDPN/XAA
RS267TDRS/XAA
RS267TDWP/XAA
Press Freezer button a
third time to Force Low
Speed Run
Wait 5 seconds between button pushes
Press Freezer button a
forth time to Force Defrost
of Fridge & Freezer,
measure defrost voltage
at main PCB
Press Freezer button one
time at the Test Mode to
Force Compressor High
Speed Run, measure fan
and Compressor voltages
at main PCB
Self Diagnosis: Press both buttons (Energy
Saver– Lighting) simultaneously (No sound
when both buttons are pressed at the same
time) ’til the display quits blinking and beeps, 8-
12 seconds, then release and read Fault Codes.
This will also cancel the Fault Mode created by
self-diagnosis at power up.
Forced Mode: Press both buttons (Lighting–
Fridge) simultaneously (No sound when both buttons
are pressed at the same time) ‘til it beeps and
goes blank, 8-12 seconds
Publication # tsRS267TD Revision Date 09/21/2010
Sealed System
Component Value Chart
Display Change F° to C° Press and Hold “Lighting”
for 3 sec.
Sales Mode, No Compressor Operation
Press Lighting & Freezer temp buttons simultaneously
for 3 sec ( you will hear a “Ding Dong”) to remove
or put into Sales Mode. When in the Sales
Mode the Display will show “OF” “OF”
Removing power will not cancel this mode.
Press Freezer button a
second time to Force
Mid Speed Run
3600RPM 2450RPM 2200RPM
Compressor → Condenser →Side Cluster → Hot Pipe→
Dryer → R Capillary → R Evaporator → F Evaporator →
Suction Pipe → Compressor
Installation Note:
2” space required
top, back & sides
Component Resistance Wattage Voltage
Freezer Defrost Heater 66Ω 218 120vac
Fridge Defrost Heater 103Ω 140 120vac
Dispenser Heater 2057Ω 7 120vac
Fill Tube Heater 3130Ω 4.6 120vac
Sensors 2.5kΩ-89kΩ N/A 1~4.5vdc
Fans N/A N/A 7~12vdc
Refrigerant Charge
R134a 7.76 oz.
NOTICE:
RS267TD PN & RS Colors
Parts Change: Refer to bulletin.
Door Handle Parts Change

tsRS267TD ReviA 09/21/2010 1