I have a dryer that will run 1 load and work fine then on the 2nd load just stops and the start button blinks. you can start it again but it will only run for 5 seconds or so and the start button will blink again. there are no error codes
- Guest asked 6 years ago
Hello
Have you run it through the diagnostic mode? A few possibilities is the door switch, motor shutting off on overload due to bad motor or drum restricted. See technician sheet to look for stored error codes.
Recalling Last Error Code:
1) Press power and look for console light up.
2) Wait at least 10 seconds, then simultaneously press and hold temp and select (set) buttons for 3 seconds.
3) The display will show the last error in memory.4Clear the display and return to normal operation by touching any button or by pressing the power button
Factory Default Reset:
1Press power and look for console light up.
2Wait at least 10 seconds, then simultaneously press and hold the dryness (dry level) and options buttons for 3 seconds. Audible signal will indicate that the settings have been reset.
- AV Repair Help answered 6 years ago
- You must login to reply
Please login first to submit.
