Ran service test. No error code. Just FE, Doesn’t have reversed polarity, amp draw on motor while running is good. Stops right at 15 minutes. So I replaced PCB, still doing the same thing.
Model Number
MDB8959SFZ4
What have you tried so far?
Replaced PCB, amp draw, checked for reversed polarity and have proper volts for the proper leg.
Request Resource Materials
Service bulletins
- Guest asked 6 years ago
- last edited 6 years ago
Hello
There are no service bulletins at this time on this unit. I would go to page the service manual link below on page 2-13 for possible causes.
Symptom
CAN START A CYCLE BUT ONLY RUNS FOR A SHORT TIME – CYCLE DOES NOT COMPLETE (CLEAN LED OR COMPLETED MAY BLINK).
Cause
CONTROL CANCELLED CYCLE DUE TO ERROR DETECTED WITH WASH MOTOR OR LOW WATER. See section 2-13 for fix.
Matt Ace technician
- AV Repair Help answered 6 years ago
- You must login to reply
Your Answer
Please login first to submit.
