I have removed the unit a few times to dry the leak sensor but it continues to error out . I cannot pinpoint the source of the leak and usually gets through one cycle then faults and all hoses look fine and connected securely, any ideas?
Initially the errors I saw , I changed turbidity sensor and element, I am thinking this may have been the cause all along ,I am thinking sump gasket or can the drain hose not having upward loop into disposer have a part in it as well due to sink backfilling.. I’m out of ideas..
- Guest asked 9 years ago
Check the sink backing up may have something to do with it, especially since the drain hose is not elevated. This can cause the water to not all drain out and water from the sink could be back filling into the dishwasher. Have you seen any water sitting in the bottom? Tracing a leak can be hard. On this unit you have to pull it out 80% of the cabinet and run it while you look in from the back or sides to see where the water is coming from. I would start by elevating the drain hose and fixing the sink drain and go from there. I have attached the tech sheet so you can check those error codes.Send us any error codes you may have.
- AV Repair Help answered 9 years ago
- You must login to reply
Please login first to submit.
