0
0

After replacing the ice maker and pushing the test button it rotated and filled good. 24 hours later there is no ice. it seems after replacing the ice maker someone pushed the ice off button. I tested the ice maker again and it cycled, dumped ice and filled again. How long should it take to harvest ice? Would there be anything else that would cause the ice not to be made besides the water valve, high temp, ice button set to off or faulty ice maker?

Just a side note, I did see some frost on the ice maker and on the top shelf but not on the back wall. I checked the door gasket and it seems to be in good shape and holding a good seal. I figured this was from someone not closing the door properly. Any ideas you may have would be greatly appreciated.

Model Number
rf263aers
What have you tried so far?

Replaced the ice maker. tested good. temperatures ok……37 fridge -2 freezer.

Refrigerator
Share
Filter
Sort by: Newest First
0
0

Hi. It sounds like every thing is working correctly. You get water to the ice maker, it does make cubes, temps are good, and the ice maker cycles in test mode. IT should take about 1.5 Hrs. to make ice if temps are correct. I always tell my customers to give it 4 or 5 hrs. to create its first batch of ice after i complete the repair. Hopefully they just had the ice maker turned off and it will now make ice. IF not have them unplug the unit to reset the control board. It could need to be reset after the new ice maker was installed. These units will go through a system check on start up and if any error codes are present it will show them in the display. If still no ice after the reset I would enter into diagnostic mode and check for errors and run any tests that can be done for the ice maker through diagnostic mode. Good luck and let me know if you need any further help.

Showing 1 result
Your Answer

Please first to submit.