Hello, I just replaced the defective touch panel. I need to know how to clear the error code on this model. Maytag dishwasher MDB4949SDZ. Thank you, Shawn
I’ve tried some pressing buttons 123 123 123.
- Guest asked 6 years ago
Hello
Service Diagnostics Cycle Notes
NOTE : Invoking Service Diagnostics cycle clears all status and last run information from memory and restores defaults. For more detailed instructions see page #6 in the Technical diagnostics mode link below. If the control is not responding make sure you installed the correct touch panel. Some of the control panels can look identical and all harness plug in but be the incorrect part because the serial number was wrong. Call 1-800-830-5465 with you MODEL & Serial number to verify it is the correct control for your dishwasher.
To invoke the Service Diagnostics cycle, perform the following while in Standby:
Press any 3 keys in the sequence 1-2-3-1-2-3-1-2-3 with no more than 1 second between key presses.
The Service Diagnostics cycle will start when the door is closed.
Matt Ace technician
- AV Repair Help answered 6 years ago
-
Hello, I hop you can help. My Dishwasher Model MDB4949SDM2. Serial number. F54032284 I received the error code e2 f2. i checked the votage from the corol board and it read over 5 volts. I replaced the touch panel. The part replaced matches exactly WD10619840D. I believe this should be the fix because the touchpad now makes noise when I hit the buttons. I need the correct procedure for clearing the e2 f2 error code. The procedure previously giver 123, 123, 123 does not seem to work or clear the codes on this dishwasher.
-
Hi. Check the part part number of the touch panel you replaced. I show the correct part number is WPW10562079. If you are still getting the error code on the display then the part is faulty or the issue could be the control board. The 123, 123, 123 sequence has to be entered with no lights on (stand by mode). So if you have the error code on the display the unit may not enter into diagnostics. Also, if the touch panel buttons are not working or responding it will not enter this mode either. Press cancel to try and get the error to go away, and with no lights on, enter the diagnostic mode. The error should not present after the new touch panel was installed. The error should not have to be cleared. If the error is still present after the new part was installed and power restored, It means the unit is still having an issue and the error code is current and it was not fixed with the new part.
-
Hello, Could was hat e2 f2 mean something else? i hear it making noise with the pump for a little where le before the code pops up.
-
Hello, Could was hat e2 f2 mean something else? i hear it making noise with the pump for a little where le before the code pops up.
-
It should not give that error for anything else. Did you verify the part number you installed was correct? Take a look at error code f2 e1 in the tech sheet. This is also a touch panel error that can also be a faulty control. It will have you run through some procedures to find out which one is bad. I would recommend doing this.
- 4 more comments
- You must login to reply
Please login first to submit.
