I tried blowing air through the drain hose and it would not go through
I ran the machine on cold water only with the cold hooked up rapid wash cycle got an A09 error
But when I ran the the machine completes cycle with no error
Carey
- Guest asked 4 years ago
Hi, I have attached the tech sheet for you. Even though you ran the unit on cold water, it could still bring in some hot water to reach the correct temp the machine thinks cold should be. This may have cause the error. Make sure both hot and cold are hooked up and working. Run through the steps for the error code in the tech sheet Run diagnostics to see if you can find a failure. You tried blowing through which end of the drain hose? Is the unit not draining? Make sure the pressure hose is clear.
- Brian, Ace Appliance answered 4 years ago
-
I triied blowing air in where the water would usually exit the drain hose. I usually put some water in the clothes drum. Air bubbles dont come up in the drum thru the water.
-
The unit drains because when i put it on rinse and spin cycle it completed with no errors
-
Sounds like the drain is fine. There are check valves on the drain hose and pumps that would prevent you from being able to blow back through the drain hose. I would make sure the hot water is working and run the diagnostics
- You must login to reply
Please login first to submit.
