Power hit while were on vacation and control panel not working correctly

Hello
See links below for use & care guide and diagnostics of your model. Matt ace technician

******* Sabbath Mode ******
The Sabbath mode feature turns off all lights, disables the water and ice dispenser, disables all alarms and tones, disables the automatic defrost feature and disables the control panel.
While the refrigerator is operating in Sabbath mode, any touch of the control panel will display the Sabbath mode control which will allow you to turn off the Sabbath mode feature.
Turn Sabbath mode on:
1. On the main menu, press the touch pad next to “Options.”
2. In each of the following screens, continue to press the touch
pad next to “More Options” until “Sabbath Is Off” appears on
the display.
3. Press the touch pad next to “Sabbath Is Off” to switch
between ON and OFF. Press the touch pad next to “Done” to
lock in the desired setting and return to the main menu.

****** Control board Troubleshooting *******
Programming Mode:*******: The Program Code is located on the Serial Plate on this unit after the word Code.
1. Press and hold the WATER Keypad.
2. Press and hold LL Keypad.
3. Release the WATER Keypad and wait 3 seconds.
4. The control will display PE to indicate the programming mode.
5. Entry is confirmed by pressing the LL Keypad once more.
6. The control will display the current Program CODE. This value should be validated with the Program CODE printed on the unit serial plate.
****** If the Program CODE is correct, the Programming Mode is exited by pressing water Keypad for 3 seconds.
7. Press the UR Keypad or LR Keypad to change the digit value with each key press.
8. The decimal point indicates the selected digit. Press the UL Keypad to select the next digit.
9. Once the desired Program CODE is entered, press and hold the LL Keypad until the Program CODE begins flashing indicating it has been
saved.
******: If you attempt to enter an invalid Program CODE the control will not save the new code, but will beep. (The unit will NOT run with a
Program CODE of 0000). Once the Program CODE has been saved the Programming Mode is exited by pressing any key or by opening or
closing the refrigerator door. If the new code is incorrect this process should be repeated.
The Programming mode can be exited at any time by pressing WATER key for 3 seconds or will exit if unattended for four minutes.
Defrost Operation:
The Control Board adapts the compressor run time between defrosts to achieve optimum defrost intervals by monitoring the length of time the
defrost heater is on. After initial power up, defrost interval is 4 hours compressor run time. Defrost occurs immediately after the 4 hours