Niether water or ice entering the ice maker and no water coming out from the dispenser
We replaced the housing water filter and filter itself we checked the water tank inside the door bottom found no leak I also check the ihoses in back of the refrigerator still no leak we put the refrigerator on test mode and nothing is showing except 0000 can it be possible that RFID need to be replace and what is the purpose of RFID
- Victor12 asked 5 years ago
- last edited 5 years ago
Hello
The display will show 00 in the freezer temperature display and 00 in the fresh food temperature display. This
is the setting to access the Service Diagnostic Tests.The service mode will time out and go back to the main screen if no tests are performed within 5 minutes. To exit without resetting the boards, hold the WATER & CUBED pads together down until prompted with ENTERING SERVICE MODE? then select YES TO EXIT. Then set the SERVICE MODE to 0016 and press GO. The complete tests are on page #105 in the service manual link below.
RFID chip information. The service manual also has additional information.
On bottom freezer refrigerators that use the RPWFE water filter, the unit uses radio frequency identification (RFID) to detect leaks and monitor the filter status. The water filter cartridge is located inside the cartridge holder in the upper left corner of the fresh food compartment.
GE Appliances recommends refrigerators with water filtration system use only genuine GE Appliance water filters. This helps prevent water leaks. The RFID component is part of the overall system that communicates with the refrigerator and shuts off the water supply in the event a leak is detected. Non-GE filters and counterfeit filters without this technology will not perform the same way in the event of a water leak. The refrigerator has the option to use a bypass plug should you not want to use a genuine GE Appliances water filter. Refrigerator – Bypass Plug.
The RPWFE filter will not shut off the water supply if a new filter is needed. The control will show expired and ask the user to accept continuing use with expired filter risk.
When the Replace Water Filter indicator appears, replace the water filter (or put in the bypass plug). The RFID will then automatically reset the Replace Water Filter reminder when a new RFID filter or the bypass plug is installed. The reminder cannot be manually reset.
- AV Repair Help answered 5 years ago
- You must login to reply
Please login first to submit.
