Not heating

Jose, also the email address you registered with is not valid. Please email service@appliancevideo.com with a valid email address.

Most of the time the cycle blinking light indicates an error code depend on how many times it blinks. They are prone to heater error issues which could be either board in line thermostat or heater. easiest way to find the issue is to get the tech sheet from either behind bottom panel or from behind door panel. once you get the tech sheet you can put through diagnostics or go straight to board and ohm out the heater and thermostat from board. from my experience the boards are the problem 75 percent of the time. to be certain though i would ohm out heater and thermostat and put through diag before ordering any parts.

Hi. Did you already verify the error code you get from the blinking light is for the unit not heating? This error will occur when the water temp. does not rise a certain amount during the cycle. This can be for a number of reasons including the unit not getting warm enough water. I would make sure its not an external issue first, then If you have already verified the heater is good then it’s either the thermal fuse for the heat circuit or your control board. There should be a tech sheet under the kick panel of your dishwasher. There will be a diagnostic mode you can run to check the heat circuit. Let me know if you need any further help.