When I arrived at the residence I found the washer to not take in any hot or cold water. I flipped back the control panel to start my diagnosis when the washer started to sputter a few times and then started to will with water. Now I can’t diagnose this issue. I think could be the timer or the temperature control board. I have run into this washer design a few years ago and would not start also and found that the timer had bad contacts. (this timer is hard to take apart and get back to getter so I don’t dare to take this one apart.
Can you offer any suggestions.
Thanks Chad
- Guest asked 8 years ago
I have attached a wiring diagram, a service bulletin and a complete job aid on this exact model and you will find all information available on this unit in these 3 attachments. Good luck.
- Sam, Ace Appliance answered 8 years ago
- last edited 8 years ago
- You must login to reply
Please login first to submit.