I have an Amana fridge for 15 years now. The bottom freezer just doesn’t freeze anymore but ice blocks form at the back and at the bottom. Should I try to get it service – is it worth it? or get a new fridge?
The only thing that wouldn’t be worth fixing is a freon leak or a bad compressor. Most likely that won’t be your issue, but if it is, then when you follow my instructions and remove the back panel inside the freezer, the silver coils will only be partially frosted (some on top but not on bottom). More than likely however, you either have a defrost problem or the fan inside the freezer behind the back panel isn’t running and needs to be replaced. Pull everything out of the freezer and remove the back panel. If the fan isn’t running then replace it. If there is a lot of frost build up, then use a hair dryer to thaw it all out. You will then need to test continuity through the defrost heater and defrost thermostat. The defrost heater runs along the bottom of the silver coils and the defrost thermostat is the 1″ round device clipped onto the top of the silver coils. If either part doesn’t have continuity, you need to replace it or it stops the unit from thawing on it’s own.
To remove the back panel itself, just remove all the screws going into the back panel to start. There is a plastic vent directly in the middle toward the top of the back panel that you must unclip. There are 3 hidden clips you must pry on with a flat head screwdriver to release this vent panel and below is a picture where I drew an arrow to all the clip locations you need to pry on.
To the right of this vent is a little oval plastic cover which houses a temperature sensor. Slide a flat head screwdriver into the slit on the front of the cover and pry in the hole to release this cover and get the sensor out of the way. Now you can pull the back panel off.
- AV Repair Help answered 6 years ago
- You must login to reply
Please login first to submit.
