I CHECKED OUT THE UNIT AND FOUND IT TO FILL WITH WATER AND STOP AT THE PROPER LEVEL. WHEN IT COMPLETED FILL IT WOULD NOT START THE NEXT CYCLE. I THEN REACHED UNDER THE UNIT AND HIT WHAT I THINK IS THE PUMP MOTOR AND IT STARTED. AT THIS POINT THE MOTOR WOULD RUN FOR A FEW SECONDS, THEN STOP AND START AGAIN. WHEN I OPENNED THE DOOR IT SEEMED THAT THE ARMS ARE NOT ROTATING. I NEVER WORKED ON A DISH WASHER BEFORE CAN ANYONE HELP. THANKS, TOD FROM NY.
- Guest asked 9 years ago
Hi Todd. This unit has a diverter motor. It washes one section at a time. It switches back and forth for top and bottom racks. Check the removable filter under the bottom spay arm. Make sure its hooked up to and getting hot water. This unit will pulsate the motor and drain pump on and off a few times when each one stats up or if you open and close the door. Make sure the spray arm holes are not built up with debris causing then from rotating. If you have any question about it getting enough water or not you can add water with a cup to fill it up some more and see if it makes a difference. The tech sheet on this one should be attached to the back side of the toe panel. It has a diagnostic mode that you can run a test and check for error codes. Let me know what you find out.
- Brian, Ace Appliance answered 9 years ago
- You must login to reply
Please login first to submit.
