When cycle start water fills up and drain as intended but tub not turning.
I checked belt, belt in On. Tub turning freely.
- Guest asked 3 years ago
IF THE MOTOR WILL NOT RUN , COMPLETE THE CHECKLIST BELOW.
1) CHECK FOR POWER:
Advance the timer knob to the drain
increment. If the drain pump does not run,
check household safety circuit. If the drain
pump runs go to step 2.
2. CHECK FOR MOTOR MOVEMENT:
Turn the water off to the washer. Remove
electrical power from the washer and
remove the back panel. Remove the motor
drive belt. Reconnect electrical power and
set the timer to the start of the Regular wash
cycle and pull the knob out. If motor does
not rotate, check for a poor connection in the
timer line switch or door lock switch. If good,
and motor does not run go to step 3.
3. MEASURE VOLTAGES:
Remove the six pin plug from the speed
control unit. Measure the voltage between
pins 5 and 6 on the harness. If the meter
reads 0 check the connection in the timer
line switch or door lock. If the meter
reads 120 Vac .
See complete technician sheet link below for the next steps, if steps 1-3 do not correct your issue.
- AV Repair Help answered 3 years ago
- You must login to reply
Please login first to submit.