no rinse

Couple of thins to look for. Is the unit draining by itself or is the water being pumped out? Can you her the pump working to drain the water in the rinse cycle?

If the pump is not running or removing the water you most likely have a a siphoning issue. Recheck your drain line and make sure the line is positioned correctly, check your standpipe and make sure the hose is not shoved to far down in, make sure the “goose neck” is in position on the drain line to help with proper water flow.

If it is the pump pumping out the water you will want to recheck all of your connections on the board you installed. If one of the wires was attached to the in correct terminal the board may be telling the pump to run at the wrong time. Refer to the wiring diagram to make sure.

If you have checked these options then most likely you have purchased a defective board and may have a relay sticking causing that pump to run at the wrong time.

Hope this helps!

Since you have replaced the Control and made sure there is cold water coming to the unit, when the unit is in the rinse does it fill with cold water? The shifter that engages the basket to spin or agitate might not be working correctly. To check the shifter correctly you are going to have to locate the Tech sheet it is usually hidden be hind the front panel but maybe located in the back of the unit. I would recommend finding this before proceeding any further with repairs or parts replacements. Let me know when you locate it so i can help you.