No power, I am not getting any display option

Hello
Are this the board part numbers you replaced # WPW10312695 # WPW10708780. If so did you program the board . See instructions below
Programming Mode:NOTE: The Program Code is located on the Serial Plate on this unit after the word Code.1. Press and hold the WATER Keypad.2. Press and hold LL Keypad.3. Release the WATER Keypad and wait 3 seconds.4. The control will display PEto indicate the programming mode.5. Entry is confirmed by pressing the LL Keypad once more.6. The control will display the current Program CODE. This value should be validated with the Program CODE printed on the unit serial plate.NOTE:If the Program CODE is correct, the Programming Mode is exited by pressing water Keypad for 3 seconds.7. Press the UR Keypad or LR Keypad to change the digit value with each key press.8. The decimal point indicates the selected digit. Press the UL Keypad to select the next digit.9. Once the desired Program CODE is entered, press and hold the LL Keypad until the Program CODE begins flashing indicating it has been saved.

Hello
I have provided you with the diagnostics and parts breakdown. If you cannot get display to light to get it into the diagnostic mode try shutting off the unit for 10-minutes to reset the board. If that does not work you will have check for power and the display board. If you have power their replace display control assembly. Once you get a display run the unit through diagnostics to make sure there are not any stored error codes that could cause other issues. Matt Ace technician