This unit stopped working after a storm took the power out. I have verified that I am getting 120vac at the main board. The user interface is completely dead and unresponsive though. I have tried to put it in diagnostic mode and it does nothing. No lights at all on the user interface.
Verified 120vac to main board. Looked both boards over to see if any obvious short and all looks normal.
- Guest asked 6 years ago
Hello
See the complete diagnostic link below.
To reset the CSM. (GE Technicians use Laptop Diagnostics Program)
Entering Service Mode will reset the CSM.
To enter Service Mode:
1. First enter Consumer Error mode as directed previously. After the ten (10) second door check
has completed, continue to next step.
2. Enter Service mode (while in Consumer Error Mode), by pressing and holding the Select Cycle
button for five (5) seconds.
Fill, circulate, heater and drain tests can be selected by using the Select Cycle button. To start each
test, press the Start button.
- AV Repair Help answered 6 years ago
- You must login to reply
Please login first to submit.
