I HAVE A CUSTOMER THAT HAS A COMMERCIAL MILNOR WASHER. THE UNIT WILL GO THROUGH CYCLES UNTIL IT REACHES 19 MIN. IT THEN STAYS IN THE WASH CYCLE AT 19 UNTIL IT SHOWS A CODE FOR A BAD PRESURE SWITCH. I CHANGED THE PRESURE SWITCH AND CALIBRATED IT. WHEN I LEFT IT, THE UNIT WAS DOWN TO 15 MIN. I WILL CALL TO FIND OUT WHAT IT DID. IT SEEMED TO ME THAT THE CYCLES WERE TAKING TO LONG, AND NEVER DRAINING WATER EVEN THOUGH IT SAID THE UNIT WAS IN THE DRAIN CYCLE. ANY GUIDANCE OR HELP WOULD BE GREAT, THANKS, TODD FROM NY.
- Guest asked 9 years ago
Hi Todd,
I am not finding any look up on this unit for parts or service information. You say the unit is not draining the water out? This can cause your pressure switch water level error code. The washer is not recognizing a water level change so it will throw this error. Also, a clogged or damaged pressure hose will cause this error code and a faulty board or control as well. If the unit has water in the tub it is going to try to drain it at the beginning of any cycle. This could be why it will not start the cycle for 19 mins. I hope this helps. Let me know how it goes.
- Brian, Ace Appliance answered 9 years ago
- You must login to reply
Please login first to submit.
