So I had a noise filter burn up. Checked the magnetron and it’s bad. So replaced mag, cap and diode and as soon as youug it units trips the breaker. I’ve check all the wires and all the components and I can find what’s grounding causing the breaker to trip. Any ideas?
Traced wire for wire. Repainted inside of the microwave, meter test all components.
- Guest asked 9 years ago
Hi. I had this happen to me before after I installed a capacitor. I put the wires back on correctly, but I put the diode on the opposite side on the cap which was causing the issue. If all your wiring is good and nothing is shorted to ground, I would check the door switches next.
- Brian, Ace Appliance answered 9 years ago
- You must login to reply
Please login first to submit.