Hey I have a all in one washer dyer combo that is not drying the clothes. I replaced the drain pump and cold water inlet valve (all four). The clothes come out hot but soaking wet. The dyer works by putting hot air in the drum then running that hot air over an evaporation coil to remove the moisture. Then that water is drained. Then it puts more hot water in the drum again and starts the process over. Can you give me a parts list of possible bad components to try switching out sorted most likely to least likely?
I replaced the drain pump and cold water inlet valve (all four).
- Guest asked 4 years ago
Hello
There are many possibilities for your symptom. You will need to run the unit through the load test mode on page #16 in the service manual link below. This will run run the unit through diagnostics and give you the troubleshooting recommendations on what part is needed. On pages #40 through #45 are the complete parts breakdown of this washer / dryer. I have also added a link to a washer/ dryer combo WM3488HW that has 22 videos. It is very similar to your unit.
- AV Repair Help answered 4 years ago
- You must login to reply
Please login first to submit.