installed main control board #W10890094 and went to follow steps to reprogram with code inside of door and the display lights are just flashing and will not let me enter Programming mode, there is no numbers displaying just light flashing of lights. With my old board you can see the numbers bright like always no flashing
installing new main control board
ppushing the door alarm and freezer down button trying to enter PE mode
- Guest asked 4 years ago
- last edited 4 years ago
Hi. Make sure you are entering program mode correctly. It can be tricky. I have attached the tech sheet which has the program instructions. I verified you installed the correct control.
Programming Mode:
NOTE: The Program Code is located on the Serial Plate on this unit after the word Code.
1. Press and hold the Door Alarm Keypad .
2. Press and hold Freezer Temperature Down Keypad within 3 seconds .
3. Release the Door Alarm Keypad and wait 3 seconds.
4. The control will display PE to indicate the programming mode.
5. Entry is confirmed by pressing the Freezer Temperature Down Keypad once more.
6. The control will display the current Program CODE. This value should be validated with the
Program CODE printed on the unit serial plate.
- Brian, Ace Appliance answered 4 years ago
-
Thank you fo your reply, my concern is there is no readable numbers or letters on the display after plugging unit back it, just light flashing of lights I hold the buttons down in sequence as referenced and nothing changes no PE on display nothing changes
- You must login to reply
Please login first to submit.
