1
0

I replaced ice tray and clip for thermister on tray. It is seating properly and firmly against the bottom of the ice tray. Ice maker actuated but when rotating tray 1/2 inch it hits Icemaker arm I suppose a switch inside arm tells Icemaker to return to original position.

I primed the ice tray with some water and it dumped the cubes in the bucket but did no subsequently fill with water.

I checked the water valve by temporarily moving the dispense connector on the water valve to the ice maker water valve and water flowed into ice tray when I pressed water dispense on outside of fridge.

How do I do an electronic fill test using diagnostic mode . I am buying Icemaker and would like to fully test before leaving the location .

Model Number
Lsc27926st
What have you tried so far?

Replaced ice tray
Replaced clip on tray for thermistor
Checked water valve good

Request Resource Materials
Service diagnostics guide, Wiring diagram, Parts breakdown, Service bulletins, Service pointers, Job aids, Videos, Any available materials
0
0

Hi. I have attached a similar but not exact service manual for you. With everything you have explained and all the testing you have done, sound like you either have a faulty ice maker or control board.

    • Guest
    • 8 years ago
    Trying to initiate a fill by unplugging and plugging fridge with icemaker on. Ice maker starts to cycle but stops at the tab on the arm. Should I raise the arm slightly so the twisting tray will continue full cycle past the arm and then start a fill? How do I start a ice maker test sequence to sends 115 volts to ice maker fill valve.
  • On the bottom of the head of the ice maker there is a button. Press and hold this button in for about 10 seconds until the ice maker starts to cycle and let go. This runs a complete cycle for the ice maker.
0
0

Hello
See complete troubleshooting and diagnostics on page #48 in service manual link below. Also see service bulletin on ice maker link. Matt Ace technician

Showing 2 results
Your Answer

Please first to submit.