after I replace the main control board , the interface control only flashing PEO 00. I think it need to reset, but I don’t know how.
Check all the wires make sure they are tight.
- Guest asked 8 years ago
- last edited 8 years ago
Control board Troubleshooting
Programming Mode:
Important : The Program Code is located on the Serial Plate on this unit after the word Code.
If you attempt to enter an invalid Program CODE the control will not save the new code, but will beep. (The unit will NOT run with a
Program CODE of 0000). Once the Program CODE has been saved the Programming Mode is exited by pressing any key or by opening or
closing the refrigerator door. If the new code is incorrect this process should be repeated.
The Programming mode can be exited at any time by pressing WATER key for 3 seconds or will exit if unattended for four minutes.
1. Press and hold the WATER Keypad.
2. Press and hold LL Keypad.
3. Release the WATER Keypad and wait 3 seconds.
4. The control will display PE to indicate the programming mode.
5. Entry is confirmed by pressing the LL Keypad once more.
6. The control will display the current Program CODE. This value should be validated with the Program CODE printed on the unit serial plate.
NOTE: If the Program CODE is correct, the Programming Mode is exited by pressing water Keypad for 3 seconds.
7. Press the UR Keypad or LR Keypad to change the digit value with each key press.
8. The decimal point indicates the selected digit. Press the UL Keypad to select the next digit.
9. Once the desired Program CODE is entered, press and hold the LL Keypad until the Program CODE begins flashing indicating it has been saved. See video link for ( KFSI) Series control board . Matt Ace Technician
- AV Repair Help answered 8 years ago
- You must login to reply
Please login first to submit.
