Do you have a video on how you replace the bake element on this double oven. I also like to know if you have a diagnosis sheet or cheat sheet that I can put the unit into diagnostic mode? I don’t have anything on this oven except a schematic. Takes a long time to get to preset temperature 30 min.
Incoming power from 50 amp breaker panel o.k., incoming power to unit all connections and wires are tight. getting 230vac. Computer board no burning or anything that looks out of place. Ohm out upper bake element and sensor at room temperature. Also did the lower oven all o.k. It does show that it has a bake element but you can’t access from the bottom of the oven according to the schematic. So how do you get to the bake elements. Do you have to pull the whole unit out of the wall and get behind the unit. This is been a real problem and you have no video’s on this unit. Please help me out on this one.
- Guest asked 9 years ago
I have attached the tech sheet for you on this unit.
- Brian, Ace Appliance answered 9 years ago
- You must login to reply
I believe you have a hidden bake element.To access this you must take remove oven door so bottom panel can slide up and out exposing bake element and then it can be removed (with power off!) and checked for continuity with your ohm meter.(usually approximately 28 ohms or so).If bake element is good then oven control most likely is bad.
- Sam, Ace Appliance answered 9 years ago
- You must login to reply
Please login first to submit.
