I changed the main control board and I am unable to save the code I enter. I know the code because it is shown inside the fridge. Once I add the code from the display, I press the button then it doesn’t save.
I have tried to save the code by pressing the button but whenever I leave the screen and go back to it, the code is not there anymore.
- Guest asked 9 years ago
Was the control you replaced on the back of the unit? ( the H.V board) I show this board as a p# 12920710. Link is attached for part.
- Brian, Ace Appliance answered 9 years ago
- You must login to reply
Hi. Here are the instructions on programming the new board. I have also attached a video. Once you enter the code you press the freezer temp. down key until the display starts flashing. This means it is saved. At this point you can close the doors and when you open them back up it will show a normal display and the unit should be running at this point as well.
Programming Mode:
NOTE: The Program Code is located on the Serial Plate on this unit after the word Code.
1. Press and hold the Door Alarm Keypad .
2. Press and hold Freezer Temperature Down Keypad within 3 seconds .
3. Release the Door Alarm Keypad and wait 3 seconds.
4. The control will display PE to indicate the programming mode.
5. Entry is confirmed by pressing the Freezer Temperature Down Keypad once more.
6. The control will display the current Program CODE. This value should be validated with the
Program CODE printed on the unit serial plate.
NOTE: If the Program CODE is correct, the Programming Mode is exited by pressing Door Alarm
Keypad for 3 seconds.
7. Press the Refrigerator Temperature Up Keypad or Refrigerator Down Keypad to
change the digit value with each key press.
8. The decimal point indicates the selected digit. Press the Freezer Temperature Up Keypad to
select the next digit.
9. Once the desired Program CODE is entered, press and hold the Freezer Temperature Down Keypad
until the Program CODE begins flashing indicating it has been saved.
NOTE: If you attempt to enter an invalid Program CODE the control will not save the new code, but will
beep. (The unit will NOT run with a Program CODE of 0000).Once the Program CODE has been
saved the Programming Mode is exited by pressing any key. If the new code is incorrect this
process should be repeated.
The Programming mode can be exited at any time by pressing Door Alarm key for 3 seconds or
will exit if unattended for four minutes.
- Brian, Ace Appliance answered 9 years ago
- You must login to reply
Please login first to submit.
