When I press bake or broil the clean cycle starts. When I press the time set and press the minutes it goes to 350 bake. Is this the EOC or touch pad? How can I determine which one?
I didn’t see in the tech sheet how to enter the diagnostic mode. Can you explain?
- Guest asked 8 years ago
PROBLEM: Bake Temperature Needs- See complete diagnostic link below .
Adjustment
1. Press BAKE pad for 5 seconds. The default temp. 0°
or a previously entered offset temperature will show
in the Temperature Display.
■ Press the TEMP pad “up” arrow ( ) to increase
the temperature in 10° F or 5° C increments.
■ Press the TEMP pad “down” arrow ( ) to decrease
the temperature in 10° F or 5° C increments.
Maximum offset temperature adjustment is ±30° F or
±15° C.
2. Press the START pad to save the temp. adjustment.
Before servicing, perform the following checks:
The most common cause for control failure is corrosion
on connectors. Therefore, disconnecting and
reconnecting wires will be necessary throughout test
procedures.
All tests/checks should be made with a VOM or DVM
having a sensitivity of 20,000 ohms per volt DC or
greater.
Check all connections before replacing components,
looking for broken or loose wires, failed
terminals, or wires not pressed into connectors
far enough.
Voltage checks must be made with all connectors
attached to the boards.
Resistance checks must be made with power cord
unplugged from outlet, and with wiring harness or connectors disconnected .
- AV Repair Help answered 8 years ago
- You must login to reply
Please login first to submit.
