Initially I tested Voltage is going to motor but did not hear drain pump start.
The pump is rusty I show voltage and 5.2 k ohms on motor and 10k ohms shorted to case.
Model Number
GLDA696MSS
What have you tried so far?
Unplugged cleared water then ran diagnostic test and red wire showed live voltage when pump activated from console panel.
What is the connection to pressure switch what number pin do I put connector. There are three pins and not sure which one it goes back on. Didn’t take a picture for once.
Request Resource Materials
Service diagnostics guide, Wiring diagram, Service bulletins, Service pointers, Job aids, Videos, Any available materials
- Guest asked 8 years ago
Hello
See links below for diagnostics & troubleshooting guides. Also see two different wiring diagrams in the links below. This should show you the connection to pressure switch what number pin do I put connector. Matt Ace technician
- AV Repair Help answered 8 years ago
- You must login to reply
Your Answer
Please login first to submit.
