We have to keep pushing the start button on our Kenmore Ultrawash Quiet Guard Standard dishwasher from 4-6 times before it keeps running. When you first start it, it will fill (it starts and run for less than 30 seconds). When the fill stops and it’s ready to go to the next thing, it stops and all of the lights on the control panel go out. We push start again and it will run for another few seconds, then the lights go out again. This process repeats several times. After pushing start for the initial time and then again 4-5 times, it will finally continue to run and successfully complete the cycle. Can you offer any guidance for this? This dishwasher is only a couple of years old… no more than 3.
Thank you for any help you can offer.
Tracy Monroe
Corydon, Indiana
- Tracy Monroe asked 10 years ago
remove bottom kick plate remove electrical cover shut off power to unit check wire nuts for loose connection if connections are good and tight replace main board located between door panels if problem persists after replacement of main board may need wire harness that is a little more involved of a job hope that helps you out
- Guest answered 10 years ago
- You must login to reply
Please login first to submit.
