The washer is producing a suds and f35 error I replaced the pressure switch w10415587. Any suggestions ? I arrived washer was putting up a f35 and suds error. I opened up and made sure the coin catch in the pump was clear there was nothing in the catch in the pump. I replaced the switch w10415587 I don’t have the f 35 error anymore however the suds error is still there. Any assistance would be appreciated.
- Don Kopecky asked 9 years ago
- last edited 9 years ago
95% of the time the pressure switch takes care of this problem, the other 5% ends up being the main control board. Always check the drain pump first, and that the pressure hose is clear. If that is all good, pressure switch next. In rare cases you will need the board which should be your fix. I have had a couple washers with the same codes, and both times the error code came up almost immediately after starting machine in the fill cycle (main control board). Any time you replace a control part on these washers, it is a good idea to run it thru the Calibration cycle. In most instances, placing it in the spin cycle while it is empty will suffice.
The pump can be tricky to diagnose, however it is designed to drain a full tub (for Cabrio 5-7 gallons), in under 30 seconds. If the impeller has become loose on the shaft, it may appear to drain, but not at peak efficiency. The impeller should have absolutely no play in it when spun. It should jump in increments only with no back and forth motion.
- AV Repair Help answered 9 years ago
- You must login to reply
Please login first to submit.
