I have a Samsung refrigerator. This is a French door unit.
The back panel in the fresh food compartment was solid ice the evaporator fan blade was frozen half way up.
I pulled the plug defrosted the back took it out. Replaced the evaporator fan. Plugged it back in the display, located inside at top showed 88 on the freezer side of control and the fresh food side of control. The evaporator fan was not running. I did have both doors open about 3 hours and ran a steamer inside to defrost the back panel.
The settings will not respond at all and the fan is not running. Is there something I need to reset? Thanks In advance
- Fred Abernethy asked 10 years ago
Were any of the LED segments on the display flashing? This could indicate an error code depending on which segment is flashing. See diagnostic chart below.
RF263AEBP/XAA
RF263AEPN/XAA
RF263AERS/XAA
RF263AEWP/XAA
French Door Refrigeration
Self Diagnosis: Press the Pwr Freeze—Pwr
Cool buttons simultaneously for 8-12 seconds
(No sound when both buttons are pressed at
the same time) until the display quits blinking.
Release the buttons and read Fault Codes.
This will also cancel the Fault Mode created by
self-diagnosis at power up.
Forced Mode: Press the Pwr Freeze– Fridge
buttons simultaneously for 8-12 seconds
(No sound when both buttons are pressed
at the same time) until the display beeps
and goes blank.
Publication # tsRF263AE Revision Date 11/24/2010
Sealed System
Component Value Chart
Sales Mode, No Compressor Operation
Press Power Freeze & Freezer temp buttons
simultaneously for 3 sec ( you will hear a ―Ding
Dong‖) to remove or put into Sales Mode. When
in the Sales Mode the Display will show “OF” “OF”
Removing power will not cancel this mode.
Refrigerant Charge
R134a 5.64 oz.
Component Resistance Wattage Voltage
Freezer Defrost Heater 60Ω 240 120vac
Fridge Defrost Heater 120Ω 120 120vac
French Mullion Heater 1323Ω 10 120vac
Fill Tube Heater 1323Ω 10 120vac
Sensors 2.5kΩ-89kΩ N/A 1~4.5vdc
Fans N/A N/A 7~12vdc
Press Freezer button one
time at the Test Mode to
Force Compressor High
Speed Run, measure fan
and Compressor voltages
at main PCB
Press Freezer button a
second time to Force
Mid Speed Run
Press Freezer button a
third time to Force Low
Speed Run
Press Freezer button a
- AV Repair Help answered 10 years ago
- You must login to reply
Please login first to submit.
