I had a client move the unit so that flooring could be installed. When put back in place the unit is throwing an H2O code. There is no water obstruction and will start to fill then shut off.
Have reset the unit by unplugging
Checked for obstructions, and there are none.
Have reset the unit by unplugging
Checked for obstructions, and there are none.
- Guest asked 9 years ago
Hi. Have you taken the fill hoses off the back of the unit and put them into a bucket and turned the water back on to make sure you have water pressure to the unit? Are you using flood safe hoses? They can cut off water flow to the washer. I have attached the Service Manual to the unit as well as some repair videos. I would go into the service mode and run the test modes for the water valves to see what is going on with it. IT shows how to do this in the manual.
- Brian, Ace Appliance answered 9 years ago
- You must login to reply
Please login first to submit.
