HAVE NO SERVICE MANUEL OR TECH SHEET, GOES THRU THE CYCLE TILL IT GETS TO THE SPIN CYCLE AND IT SPINS MEDIUM SPEED DRAINS OK. EVEN WITH THE FASTEST SPIN ON IT WONT GO FULL SPEED. PLUS THE TIME JUMPS AROUND AND THEN SHUTS OFF AUTOMATIC. TRIED A NEW CONTROL BOARD DIDN’T WORK. LOOKED ON PICS FOR IT FOR A RPS SENSOR IT DOESN’T HAVE ONE JUST A MOTOR PROBABLY A BUILT IN ONE. DIDNT KNOW IF I SHOULD GO THERE OR SEE WHAT YOU GUYS CAN COME UP WITH. IT HAS TWO BOARDS INSTEAD OF THREE. TOUCH BOARD IN FRONT SEEMS TO BE WORKING OK. NOT MUCH TO THIS MACHINE. ANY HELP WOULD BE NICE. THANKS
TRIED A NEW CONTROL BOARD.
- Guest asked 7 years ago
Hello
See technician diagnostic sheet link below. I would start by runiin g the unit throgh diagnostics.
Matt Ace technician
SERVICE DIAGNOSTIC MODE
These tests allow service personnel to test
and verify all inputs to the machine control
electronics. You may want to do a quick and
overall checkup of the washer with these tests
before going to specific troubleshooting tests.
ACTIVATING SERVICE DIAGNOSTIC MODE
1. Be sure the washer is in standby mode
(plugged in with all indicators off).
2. After initial power is applied, wait
30 seconds before activating Service
Diagnostic mode.
3. Select any three (3) buttons (except
POWER) and follow the steps below, using
the same buttons. Remember the buttons
and the order that the buttons were pressed.
Within 8 seconds,
• Press and Release the 1st selected button,
• Press and Release the 2nd selected button,
• Press and Release the 3rd selected button;
• Repeat this 3 button sequence 2 more times.
4. If the Service Diagnostic mode has been
entered successfully, all indicators on the
console are illuminated for 5 seconds with
“888” or “88” showing in the Estimated Time
Remaining (Whirlpool) or Estimated Cycle
Time (Maytag) seven-segment display. If
there are no saved fault codes, all indicators
on the console will momentarily turn off,
and then only the seven-segment display
will come back on and display “888” or “88”.
NOTE: The Service Diagnostic mode will time
out after 10 minutes of user inactivity, or shut
down if AC power is removed.
- AV Repair Help answered 7 years ago
- You must login to reply
Please login first to submit.
