I am having trouble repairing this stackable.
The issue is due to the washer cycle not going through all the way. Initially the error code said a lid switch fault a couple months ago. We replaced the lid switch a few months ago and worked fine, then the issue popped up again which the control board was replaced. Now the washer will go into the cycle not draining and the lid is still locked and not opening. We replaced the actuator, both the control panel board and the washer main board and lid lock. I am unsure on what else the issue could be as no error codes pop up and this will only happen intermittently.
actuator, both the control panel board and the washer main board and lid lock.
- Guest asked 6 years ago
HI. I have attached the service manual for you. Run the diagnostics to check for stored error codes. Then run the diagnostics to test each component. Page 2 tells how to enter diagnostics and page 3 tells how to activate each test. You can test everything hear. water valves, lid lock, agitate, spin, drain etc., to see which component is not working properly.
- Brian, Ace Appliance answered 6 years ago
- You must login to reply
Please login first to submit.
