I have 100v to evap fan motor does not run ..so I installed new control board same problem no tech sheet any idea I’m at a lost I’m think we have bad wire in wall ?
Control board
- jerry coyne asked 7 years ago
Yes, its in the diagnostic link information. Click on the link its on the last page.
- AV Repair Help answered 7 years ago
- You must login to reply
Hello
See link below for technician diagnostic sheet. See complete test procedure for the evaporator fan motor. Very unlikely to have a bad wire in the wall. Are you sure your meter is calibrated properly? Run the evaporator fan motor diagnostics with the instructions below. Matt Ace technician
Service Test Mode:
The service test functions are performed using the Refrigerator Temperature Display and Keypad. Enter the
Service Test Mode by performing the following sequence of events:
1. Hold the refrigerator door light switch closed.
2. Press the Refrigerator Temperature UP /+ keypad 3 times consecutively.
Note: The 3 keystrokes must be done consecutively and within 10 seconds.
3. Release the refrigerator door light switch.
4. The control will display S – E to confirm entry into the service mode.
5. Entry to the Service Menu is confirmed by pressing the Refrigerator UP /+ key once more.
6. The control will display its software version for 3 seconds.
7. Following the software revision display the freezer display will read the first test number in the diagnostic tree.
The refrigerator display will be blank.
Note: All control functions will be turned off (Compressor, Defrost, Evaporator Fan, the damper will remain in its
current position).
8. You are now in the SERVICES TEST operational mode and may use the diagnostic tests.
The Service Test Mode can be exited at any time by closing the Refrigerator Door(s).
The Freezer Temperature UP /+ DOWN /- keys allow selection of the test to be performed
EVAPORATOR FAN MOTOR TEST :
Service Test 3 – Evaporator/Freezer Fan Test
When selected and activated this test will operate the freezer fan. The Refrigerator Temperature UP /+ key will
toggle between O / F (ON & OFF) the fan drive circuit. You will have to inspect the fan for proper function. The
test must be “deactivated” or in the OFF position to move to another test selection. Observe Fan Operation,
Freezer displays 3 – Refrigerator displays O or F.
Evaporator fan motor specifications
Clockwise 2800 RPM
3.7 or 6.0±15% watts@115
- AV Repair Help answered 7 years ago
-
Meter is good weird one I ran neutral to fan from icemaker to get it to run but runs all the time now . do you know where I could find wire diagram?only 100 v to fan
-
For your information the new board I put in was bad and was doing the exact same thing as old one put another one in works great I never had a new board do the exact same thing thanks whirlpool
-
That is a new one for us also. I am glad you rectifyied the issue…
- You must login to reply
Please login first to submit.
