ihave a whirpool duet steam washer changed pressure sensor still f 35 pump is fine pressure tube is clear
- Guest asked 9 years ago
Hi. If the pressure switch did not take care of it and your sure the hose is not clogged and does not have any holes, then the control board is likely the culprit. The CCU board. P#W10180782. There is also a steam board and a motor control board. I would not think the motor control has anything to do with this issue, but the error code does say that this error code is displayed when there is a malfunction of the steamer component detected by the Steamer Electronic Board. So the steamer or the steamer board are possibilities as well. Are there any other error codes displayed in the system? Will it run through a diagnostics test cycle? Attached are a couple videos on the F35 error code and a forum I found that talks about this error.
- Brian, Ace Appliance answered 9 years ago
- You must login to reply
Please login first to submit.