GOOD EVENING. WASHER IS SHOWING AN F07 CODE. I HAVE NEVER DEALT WITH THIS BEFORE, ANY HELP WOULD BE GREAT. THANKS, TODD FROM NY.
- Guest asked 8 years ago
Hello
F07 Error
If the motor speed is not controlled then it will switch OFF the motor and wait for the speed decreased to 0rpm. At the second occurrence in the same wash phase it will go to ERROR mode.
Run Quick Diagnostics Test to check motor drive system.
7) Check the drive motor for powered rotations.
2. Unplug washer or disconnect power.
3. Check wire harness connections to the motor, and Central Control Unit (CCU).
4. Check the drive system for any worn or failed components.
5. Plug in washer or reconnect power.
6. Check the CCU by looking for operations of the drive motor.
See technician sheet below Matt Ace technician
- AV Repair Help answered 8 years ago
- last edited 8 years ago
-
THANKS MATT. HOW DO I CHECK THE DRIVE MOTOR FOR POWER ROTATIONS?
-
See Job Aid attachment
-
HI MATT. CHECKED OUT THE WASHER. OHMED OUT THE MOTOR AND IT CHECKED OUT FINE BETWEEN ALL PINS. CHECKED ALL CONNECTIONS AT MAIN CONTROL BOARD, LED DISPLAY BOARD, AND MOTOR. ALL SEEMED FINE. RAN THE QUICK DIAGNOSTIC AND ALL AREAS SEEMED TO WORK FINE. IF THERE WAS A PROBLEM WOULD THE ERROR CODE HAVE SHOWN AFTER OR DURING THE QUICK DIAGNOSTIC? AFTER THAT I RAN THE WASHER IN THE QUICK WASH CYCLE, AND EVERYTHING WORKED FINE UNTIL 7 MINUTES REMAINING. AT THAT POINT THE WASHER SAID IT WAS ON THE RINSE CYCLE, BUT JUST SEEMED TO BE AGITATING BACK AND FOR ABOUT 10 MINUTES. I THEN CLEARED THAT CYCLE AND RAN A NORMAL CYCLE AND IT WORKED PERFECTLY, NO CODES AT ALL. YOUR THOUGHTS? THANKS ,TODD FROM NY..
- You must login to reply
Please login first to submit.