ERROR CODE FH

Hello. Here is the information on this error code as stated in the tech sheet for your model.

Possible Causes / Procedure
• If there is no water in the unit:
– Make sure that both valves at the water source(s) are turned on all the way.
– Check for plugged or kinked inlet hoses or plugged screens in the inlet valves.
– Verify inlet valve operation.
• If there is water in the unit:
– Verify drain pump operation.
– Verify that the pressure switch hose is in good condition and properly connected to tub
and pressure switch.
1. Verify there is not a siphon problem.
2. Unplug washer or disconnect power.
3. Verify wire harness connections to inlet valves, pressure switch, drain pump, flow meter,
and Central Control Unit (CCU).
4. Check all hoses for possible leaks.
5. Plug in washer or reconnect power.
6. Verify pressure switch operation.
7. Verify flow meter operation by blowing air through the part and measuring the resistance.
8. Verify CCU operation by running a Diagnostic test or any cycle.

As you can see there are a lot of things related to this error code that could cause an issue. At what point in the cycle do you get the error code?