Error code FH

Hi Starla. The FH error code on your washer can be a lot of different things. Here is what the FH error code stands for as stated in the tech sheet on your washer.
FH
possible causes/procedures
■ If there is no water in the unit:
— Make sure that both valves at the water source(s) are turned
on all the way.
— Check for plugged or kinked inlet hoses or plugged screens in
the inlet valves.
— Verify inlet valve operation.
■ If there is water in the unit:
— Verify drain pump operation.
— Verify that the pressure switch hose is in good condition and
properly connected to tub and pressure switch.
1. Verify there is not a siphon problem.
2. Unplug washer or disconnect power.
3. Verify wire harness connections to inlet valves,
pressure switch, drain pump, flow meter, and
Central Control Unit (CCU).
4. Check all hoses for possible leaks.
5. Plug in washer or reconnect power
6. Verify pressure switch operation.
7. Verify flow meter operation by blowing air through the part and
measuring the resistance.
8. Verify CCU operation by running a Diagnostic test or any cycle

With some more information I can help you narrow it down and find out which part is the issue. First make sure that both water valves are turned on and you are getting hot and cold water to the washer. Make sure the drain is elevated roughly as high or tall as the washer is before it goes into a drain. When does the FH error code occur in the cycle? Is the washer filling, agitating, draining and spinning?