Tested element, reads good. Replaced control panel and main relay still no go? Tested heater connection on relay so means thermal fuse and wiring is fine, outlet a good 123v..? Goes through normal hour cycle but doesn’t dry..
Already asked question got French trouble shooting guide asking again
- Guest asked 8 years ago
Hi. I have attached the english tech sheet for you. IF both the heater and thermal cut off test good it would only leave the control board or wiring. These newer dishwasher do not dry well. THey will not dry like the old dishwashers. Rinse aid is a must. Make sure they use rinse aid as it will help with drying. Also, make sure they are using the heated dry option in the cycle. There is also a vent and a fan that runs to help dry. Check the trouble shooting section in the tech sheet on drying, and check the heater and dying cycle circuits in the tech sheet. You can run the diagnostic cycle and check to see if the heater comes on once it gets to that point.
- Brian, Ace Appliance answered 8 years ago
- You must login to reply
Please login first to submit.
